Tag Archive: air conditioning

Air Conditioning Repair – Diagnostic Basics

Connecting Cooling Manifold Gauges

The determination will have a high pressure (red) and a blue low pressure. The easiest way to bear in mind which line connects to the right line, is to think of a fluid within the system. A smaller sized pipe dimension would need more pressure to relocate the same quantity of fluid compared to a bigger pipe dimension. To make sure, that would mean the smaller sized pipe will have the high pressure (red) hose from your manifold gauge set. While the larger pipe will certainly have the lower stress (blue) hose from your manifold gauge collection. Yellow tube is for adding charge to your air conditioning system, big black hose pipe on 4-line scale set is for vacuuming system down to 500 microns.


Approach Temperature method

This technique can validate air conditioning refrigerant charge without linking a refrigerant scale set. Prior to you start the evaporator (inside coil above furnace) and condenser (outdoors coil) need to be clean. You will locate the method temperature level graph either in the makers installation guidelines or on the panel for the condenser. The manufactrurers’ chart will certainly be specific to the condenser you are dealing with and will vary from various other units.

Measure the temperature of the air entering the condenser in a couple of areas to calculate the average overall temperature level taking into consideration that the sunlight does not impact the result calculation. After that, find the liquid/fluid line temperature (small line) with a precise clamp thermostat. Figure out the temperature level distinction in between the fluid line temperature level as well as the exterior air temperature. The temperature level difference is the method of finding factors used for temperature calculation.

Adding cooling agent will decrease the approach and eliminating cooling agent will increase method. Enable 10-15 mins of air conditioning demand, for the readings to stabilize after cooling refrigerant agent, is added or reclaimed. Ensure you use correct recuperation containers when removing refrigerant because it is against the law to expel gasses right into the atmosphere and also comes with a huge penalty if caught.

Fluid line temperature – ambient temp = technique temperature


  • Determining Superheat tells you exactly how efficient the evaporator is functioning; usually most ideal 10 to 15 superheat for a/c.
  • Superheat is the quantity of heat included after the gas modifications from a fluid to a vapor. Proper Superheat collection point is important to an a/c system for these factors
  • Reduced Superheat could trigger fluid to get back to the compressor damaging internal components.
  • High superheat will decrease the effective air conditioning, which takes place finest when liquid refrigerant changes state from a liquid to a vapor, also if way too much superheat the compressor could overheat.
  • To gauge superheat use the reduced stress (blue) line of the cooling agent gauge set and clamp on thermistor to gauge temperature level at the suction line as near the evaporator as possible. Suction line as near evaporator outlet– saturation temperature level of the cooling agent= Superheat


Subcooling informs you how effective the condenser is functioning generally you want 10 degrees subcooling but should constantly comply with manufacturers suggestions. Subcooling is the amount of heat removed by the condenser past the point of modification from vapor to a liquid (saturation point). The appropriate Subcooling set point is important to a cooling system for these reasons.

Subcooling guarantees a strong column of liquid to the metering gadget and also if established as well reduced you could possibly get blink gas, which will influence the meter device.

High subcooling will certainly cause the refrigerant to stack up in the condensing system raising the head pressure in the compressor. With greater pressures the compressor will certainly function using, even more, electrical energy and wearing it out faster.

Thank you for seeing my blog I would appreciate any sort of feedback I could obtain, Please leave a comment on whether my info has actually aided you. I am constantly thinking about even more subjects to write so don’t hesitate to leave a remark asking about anything pertaining to HVAC-R (Home heating, Ventilation, a/c, refrigeration).